Performance of Cell Phone Controlled Model Vehicle
Megjelenés dátuma: 2020
Kulcsszó: 3D printing
Arduino
driving properties
FDM/FFF
operating schedule
Arduino
driving properties
FDM/FFF
operating schedule
Abstract:
The objective of the project was to construct a model car - with using additive technology - which is
connected to a phone via wireless communication. PLA (Poly-Lactic Acid) was used as a material to
print the units. The total weight of the model car is 690 grams including the electronic components.
The power consumption and driving properties were measured under given circumstances. Based on
our calculations, even in active use at its maximum speed of 5.16 km/h, the system is capable of at
least 3.9 hours of operation, while full charging takes only 3 hours. Consequently the model vehicle
can be continuously operated by applying two battery units.